Tag Archives: SWITCH 300-115 1.2b

SWITCH 300-115 1.2 Configure and verify Layer 2 protocols

1.2.b UDLD

UDLD VIDEO

https://www.youtube.com/watch?v=tcz-DW4J1fE

UDLD means Unidirectional Link Detection. it is mostly used on fiber links, but it is can also used on copper, to monitor the physical configuration of the cables and detect when a unidirectional condition exists,otherwise known as one way traffic.

Both sides of a connection must support udld for the protocol to effectively detect when a link goes unidirectional. when found to be unidirectional by aggressive mode the port is disabled and an alert is sent. in normal mode it is considered undetermined:

unless, for both types of media, one of the ports cannot send or receive
or one port is down and the other is up,
and in the case of fiber alone, one of the strands is disconnected

udld will disable the port

firstly, udld is globally disabled.

if enabled globally with udld enable (normal mode) or udld aggressive it is enabled on all fiber ports.  for copper ports, use the interface configuration command “udld port for normal mode and udld port aggressive, you guessed it, for aggressive mode.

 

SWITCH 300-115 1.2 Configure and verify Layer 2 protocols

1.2.b UDLD

it is not the case that udld is used on fiber ports, and loopguard is used on copper exclusively. they provide some functional differences in the network regardless of the media used. see below:

from: http://www.cisco.com/c/en/us/support/docs/lan-switching/spanning-tree-protocol/10596-84.html

loopguard_v_udld