4.1.e 6in4, 6to4

automatic 6 to 4…

http://www.cisco.com/en/US/docs/ios/ipv6/configuration/guide/ip6-tunnel_external_docbase_0900e4b1805a3c71_4container_external_docbase_0900e4b181b83f78.html#wp1055515

An automatic 6to4 tunnel may be configured on a border router in an isolated IPv6 network, which creates a tunnel on a per-packet basis to a border router in another IPv6 network over an IPv4 infrastructure. The tunnel destination is determined by the IPv4 address of the border router extracted from the IPv6 address that starts with the prefix 2002::/16, where the format is 2002:border-router-IPv4-address::/48. Following the embedded IPv4 address are 16 bits that can be used to number networks within the site. The border router at each end of a 6to4 tunnel must support both the IPv4 and IPv6 protocol stacks. 6to4 tunnels are configured between border routers or between a border router and a host.